Framing Configuration may be found in two locations:
Joist Holes – allows distributing service holes on joists according to predefined insertion rules.
Type – select the family and type that will be used for the holes. Default family is M_WF Service Holes (for Metric projects) and I_WF Service Holes (for Imperial projects).
Width (b) – shows b size of selected type.
Depth (h,d) – shows h or d size of selected type.
Define Depth (h,d) by Layer Thickness – Floor+ will automatically create new type for selected family with new depth equal to selected floor layer thickness. For service holes it is usually switched OFF.
Cut Holes – choose whether the holes will be created according to the rules listed below.
Rotate 90° – if ticked, then holes are rotated by 90 degrees. It is convenient if the family profile is not symmetric.
Array1 or Array2
A set of rules for placing many holes.
Array 1 or Array 2 – there are options to apply two array rules: Array from Base or End of the frame.
Offset from Base/End – holes offset from top or bottom rim joist top face.
Spacing – spacing between rows of holes.
Number – amount of hole rows.
Measure – select hole-measuring method: From base or end of the frame to the center, bottom, or top of the hole family.
Build in Place
Build in Place – writes Yes/No information into the hole family instance parameter if it is build-in-place or is prefabricated with the whole floor frame. Later this parameter can be used in schedules or view filters.
Cut Diagonal Cripple Joists
Cut Diagonal Cripple Joists – if ticked, then service holes will go through places with diagonal cripple joists.
Cut Sloped Rim Joists
Cut Sloped Rim Joists – if ticked, then service holes will go through places with sloped rim joists.