Add/Modify Elements

Add/Modify Elements – features for adding/modifying additional joists, support joists, bridging/nogging elements, etc.

Add Additional Bridging/Nogging/Blocking

Add Additional Bridging/Nogging/Blocking – adds additional bridging/nogging/blocking between two selected joists with predefined settings.

Additional Bridging/Nogging/Blocking sizes

Type – select the family and type that will be used for Bridging/Nogging/Blocking. 

Width (b) – shows b size of selected type.

Depth (h,d) – shows h or d size of selected type. 

Define Depth (h,d) by Layer ThicknessRoof+ will automatically create new type for selected family with new depth equal to selected roof layer thickness. 

Rotate by Slope

Rotate by Slope – rotates additional bridging/nogging/blocking by roof slope. 



Rotate 90°

Rotate 90° – Bridging, Nogging, or Blocking can be rotated 90 degrees to its initial position. 



Extend Ends

Extend Ends – extends blocking/nogging/bridging ends when it connects to joists.  

Example: Extend Ends is switched OFF:

Example: Extend Ends is switched ON:

Use Short Noggings

Use Short Noggings – makes short noggings between the joists, instead of long ones. 

Example: Use Short Noggings is switched OFF:

Example: Use Short Noggings is switched ON:

Cut Type

Cut Type – select blocking/nogging/bridging and joist connection cutting type. 

Possible options:

Example: when Cut Type = Don't Cut

Example: when Cut Type = Cut Joists

Example, when Cut Type = Cut Additional Element

Select Line-Based Element

Select Line Based Element – adds blocking/nogging/bridging according to selected line-based element.

Offset from Selected Element – writes an offset for adding blocking/nogging/bridging from selected line-based element. 

Example: when Offset from Selected Element = 0, Select Line-Based Element = opening header:

Example: when Offset from Selected Element = 200, Select Line-Based Element = opening header:

Split Studs/Joists

Split Studs/Joists – splits joists near inserted blocking/nogging/bridging.

Example: when Split Studs/Joists is switched ON:

Note: Split Studs/Joists is available ONLY IF Use Short Noggings is switched OFF. 


Offset – predefines the offset rule (from shorter or longer joist end or base. This function works for joists that are not split. It is especially used with sloped roofs. 

Joist base is at the top of the roof, and end is at the bottom of the roof. 

Offset from Base/End – predefines the offset from top or bottom of the joist. 

Spacing – distance between blockings/noggings/bridgings.

Number – number of blockings/noggings/bridgings.

Array in Rows

Array in Rows – predefines rows for bridging. 

Note: Rotate 90° has to be switched ON.

If you choose Array in Rows, then there is no possibility to use Spacing, but you have to use Number in Rows, which defines the number of bridgings in one row. 

Measure to

Measure to – measures the offset and spacing to bridging/nogging/blocking top/bottom or center. 

Frame Side

Frame Side – choose whether nogging should be applied in the center, external, or internal side of the frame. 

Build in Place

Build in Place – writes Yes/No information into the blocking/nogging/bridging instance parameter if it is build-in-place or is prefabricated with whole roof frame. This parameter can later be used in schedules or view filters.