Common Dimensioning in View


Bars Parallel or Perpendicular to View Plane – choose to show or hide dimensions between bars and to include/exclude distance to host face.


Use Smart Dimensions Configuration - use Smart Dimensions Configuration, instead of settings in Rebar Bars.



Dimensioning Rules


Dimensioning rule – choose where dimensions should be placed in view – Nearest Side, Top-left or Bottom-right.

Exclude rebar bars – controls whether rebar bars are dimensioned or not.

    if cut depth is higher than - enter value to filter out bars for exclusion.


Reinforcement Categories and Types

Switch ON/OFF to show types of reinforcement that should be dimensioned in view.



Parallel bar sets


Select whether or not to show dimensions between parallel bar sets and if to show distance to host face.


Put dimensions for single bars


Put dimensions on single bar – tick ON to put dimension on center of all visible single bars in the view

Put dimension on straight bar outside boundary of element – tick ON to place dimensions for single bar outside of the host as for other elements.

Include distance to face of host element - tick on to give distance from single bar ends to host edge

First dimension line Factor – enter factor to control gap between element and first dimension line. (See notes below.)


Split dimensions on equality


Split dimensions on equal segments – switch ON/OFF to join/separate equal dimensions in one line with expression of times*distance=total distance

Minimum number of equal segments to begin splitting – minimum number of same distances to join equal dimensions in one expression