There are several tabs for dimensioning elements in which you can define how elements on different Faces should be dimensioned.


In each tab, you can choose from different options. Some of them may vary depending on Category chosen:


Horizontal Dimensions/ Vertical Dimensions - choose options for vertical and horizontal dimensions


Measure Width/Position - turns ON Horizontal/Vertical dimensioning


Measure - choose to where dimension point should snap

    Location Point - will snap to insertion point of family

    Location Line - will snap to location line. Available for line-based elements (Structural Framing, Pipes, etc.).

    Left/Right Edge - will snap to the edges of solid body in the Family

    Reference planes - will snap to reference planes which are inside Family. Reference planes should be set to Left/Top/Center etc.

    Model lines - will snap to model lines, which are inside Family. Model lines should be perpendicular to dimension line string in the view.

   

Join Dimension Lines - if OFF, each element will have its own dimension line. That's why it's usually ON, to have fewer dimension strings.


Measure Only First & Last Element - will skip dimensioning of intermediate elements


Disconnect from Total Dimension Point - will give dimension only between measured elements


Dimension Position - select from available options where to place them

    Left/Right/Top/Bottom - dimensions will be placed at selected side, outside of all elements, to be included in Total Measure

    By Element - dimension will be placed at nearest side

    By Measure - dimension will be placed at position of dimensioned element


Text Note - enter value for text note. Works with Text Note Settings. (See relevant help file.)


Text Note Parameter - select parameter, which should be added as a note to the dimension line. Works with Text Note Settings. (See relevant help file.)


Grouping - group dimension lines by selected parameter of elements on selected Face.