E-HELPS
Contains product help information.
MEP Hangers is a rules-based software that places hangers and supports. To quickly start working with it, you will need Revit families of hangers and suppor...
Tue, 15 Nov, 2022 at 1:43 PM
‘Hanger Configurations’ are the settings for inserting or modifying hangers and supports. ‘Hanger Configurations’ reads the files specified in the ‘Config...
Mon, 20 Jun, 2022 at 2:54 PM
General This guide describes features and functionality of Revit families of hangers and supports, which were created specifically for MEP Hangers software...
Fri, 2 Dec, 2022 at 1:58 PM
General Our hanger families have several types with different rod and unistrut sizes that are most widely used. But in cases when these aren’t enough, ther...
Mon, 13 Jun, 2022 at 9:29 AM
General Our Revit families of hangers and supports are created from smaller components (bolt, nuts, washers, unistruts, rods, clamps, etc.) as shared neste...
Wed, 22 Jun, 2022 at 2:34 PM
General Our software and Revit families can be used to export drilling points for surveying equipment like Trimble Robotic Total Station or automated drill...
Fri, 26 Aug, 2022 at 2:30 PM
‘Split Configurations’ are the settings for splitting ducts, pipes, cable trays and conduits using ‘Split Elements’ command. ‘Split Configurations’ reads ...
Mon, 20 Jun, 2022 at 2:57 PM
Insert Hangers ‘Insert Hangers’ places hangers and supports on selected MEP elements. Hangers and supports can be inserted on elements of these categories...
Mon, 20 Jun, 2022 at 3:01 PM
When placing unistrut (trapeze) hangers, you might need the unistrut part to have a specific increment. With MEP Hangers, it's possible to specify an in...
Fri, 2 Dec, 2022 at 3:58 PM
‘Split Elements’ splits selected MEP elements by inserting fittings by predefined spacing rules. Part Type of the fittings must be set to Union. ‘Split Ele...
Mon, 20 Jun, 2022 at 3:03 PM