E-help

Workflow
1.  Make sure you have Rebar Shapes in your model. They should be visible in your Project Browser: If you don't have them, load them from Libr...
Fri, 23 Oct, 2020 at 3:35 PM
Rebar Configurations
First you need to select the type of column section you want to work with. Currently only rectangular section is available. Then Create configurat...
Fri, 18 Sep, 2020 at 10:03 AM
Rebar Configurations – Cover settings
Each column section can have different settings for cover. The image will show what each setting is for. Here is an example of what you might see for a give...
Fri, 18 Sep, 2020 at 10:03 AM
Rebar Configurations – Main Rebar
First you must define how many bars you want to have at the Front, Back, Center, etc. Then you go to the Stirrups tab and define which Main rebar should be ...
Fri, 18 Sep, 2020 at 10:03 AM
Rebar Configurations – Stirrups
After number and position of Main rebar have been defined, it's time to set up stirrups.  In the Stirrups rebar window there are 2 tabs: Layout –...
Fri, 18 Sep, 2020 at 10:03 AM
Rebar Configurations - Corbel
Currently, it is possible to define reinforcement for 2 corbel shapes: those with sloped bottoms and those with orthogonal bottoms. You can create your own ...
Fri, 23 Oct, 2020 at 11:48 AM
Create Rebar
To Create Rebar for a Structural Column, first of all you have to: 1. Create Rebar Configuration. 2. Link configuration to the column Type by using Column...
Fri, 4 Sep, 2020 at 11:52 AM
Modify Reinforcement
Change reinforcement settings for selected Structural Column element. Select Modify Rebar. Select rebar. Configuration window for selected reinforceme...
Fri, 4 Sep, 2020 at 11:38 AM
Update Rebar
Update Rebar will delete reinforcement that was created with the Column Reinforcement tool and insert reinforcement by using the configurations used on this...
Fri, 4 Sep, 2020 at 11:40 AM
Update by Column Link
This command will delete all reinforcement created with the Column Reinforcement tool. Then it will read information in Column Link and use the selected con...
Fri, 4 Sep, 2020 at 11:40 AM